There are a number of sysex commands and dumps that both the MR-Rack and ZR-76 use that are not documented in the MR sysex document. I've updated my MR Sysex Notes and will further revise the notes as I learn more.
fumphco on 07.05.04 @ 11:42 AM PST [link] [No Comments]
I replaced the rotary encoders on the MR-Rack today. The whole procedure took about an hour. A solder pad for one of the leads lifted off the printed circuit board when I desoldered the old encoders, so when I installed the new encoders I used a patch wire to connect the affected lead to a nearby test point on the correct trace. Other than that there were no complications. After reassembly it passed the "smoke test"; both encoders and the MR-Rack seem to work fine.
fumphco on 07.01.04 @ 01:53 PM PST [link] [1 Comment]
It was hard to find a distributor with stock on-hand. I had to order a quantity of the Bourns rotary encoders from Hammond Electronics, so I will have extras for sale if anyone else needs them.
fumphco on 06.30.04 @ 01:38 PM PST [link] [No Comments]
The Performance rotary encoder on my MR-Rack broke. I found an article that describes how to replace the ASR-X rotary encoders but the MR-Rack uses a different encoder than the ASR-X. The rotary encoders in the MR-Rack are Bourns part #ECW1D-C28-BC0024.
fumphco on 06.29.04 @ 01:14 PM PST [link] [No Comments]
Please tell me of any additional content or resource links that can be added.
fumphco on 06.28.04 @ 08:56 PM PST [link] [No Comments]
Go to: Home Music Gear Software
fumph was created by John Bair. Thanks for visiting. Please email feedback@fumph.com with your feedback.