|
MR-Rack |
Reinitialize |
There are three ways to reinitialize the MR-Rack. The
preferred method is from the front panel. If the front panel doesn't
respond, try using the power switch. As a last resort, reinitialize the
unit internally. From the front panel:
- With the power on, press and hold down the SAVE
button.
- While holding down SAVE, press the
ENTER button.
- When prompted by the screen, press the ENTER button again.
With the power switch:
- Turn the unit off and then on 8 times. When you turn it on, it
should be just long enough to see the display start to show
characters. When you turn it off it should be just long enough for
the display to go dim. On most units, a one second interval between
on and off works well. Sometimes you may need to experiment with the
interval between on and off.
- The eight time you turn the unit on, the unit should
automatically reinitialize itself and show the reinitialization
screen.
Internally:
Warning - Make sure the power is off and the power cord is
disconnected from the unit.
- Short the positive (+) side of the battery to the case of the
unit for a few seconds.
- When you turn the unit back on, it should be reinitialized.
|
